Viton Camlock Gasket

Viton Camlock Gasket Malaysia is an industrial green FKM fluorocarbon seal for compatible cam-and-groove couplings. The gasket sits inside the female camlock coupler and helps form a seal against the mating adapter. Correct material, size and condition are essential for reliable service.

FKM Camlock Gasket Overview

The current product is listed as premium fluorocarbon / FKM, described as a Viton-equivalent material. FKM is often considered where resistance to compatible oils, fuels, chemicals or elevated temperature is required. Compatibility must still be checked against the exact media, concentration, pressure and temperature.

Current Listed Sizes and Temperature Range

• Sizes: 1/2, 3/4, 1, 1-1/4, 1-1/2, 2, 2-1/2, 3, 4 and 6 inches.
• Material: fluorocarbon / FKM, Viton-equivalent.
• Colour: industrial green.
• Listed temperature range: -26°C to 204°C (-15°F to 400°F).

The listed temperature range is a material reference, not an automatic rating for every camlock assembly. Confirm the seal grade and complete system limits before use.

Typical Application Considerations

FKM camlock gaskets may be considered for compatible chemical processing, petroleum transfer, oilfield service, aviation fuelling and higher-temperature fluid-handling duties. Actual suitability depends on the fluid formulation, exposure time, temperature cycle and the rest of the hose-and-coupling assembly.

How the Camlock Gasket Supports Sealing

When the adapter enters the coupler and the cam arms close, the adapter face compresses the gasket. A seal can only perform correctly when the gasket profile matches the coupling, mating surfaces are clean and undamaged, and the cam arms engage fully.

Selection Checklist

• Confirm camlock nominal size and gasket profile.
• Identify the transferred media and chemical concentration.
• Provide minimum and maximum operating temperature.
• Check working pressure, pressure cycling and suction or discharge duty.
• Confirm coupling material and any cleaning or washdown chemicals.
• Request material documentation if required by the project.

Inspection and Replacement

Inspect the gasket before each connection. Replace it if it is cut, swollen, flattened, hardened, cracked or chemically affected. Clean the gasket groove and mating face without damaging them. Depressurise and drain the system before opening the coupling.

FKM Compared with Nitrile Gaskets

FKM and nitrile have different chemical and temperature capabilities. FKM may be preferred for certain chemicals, fuels and higher temperatures, while nitrile may be suitable for many compatible general industrial and oil-related duties. Selection should be based on service conditions, not colour alone.

Frequently Asked Questions

Is this gasket made from branded Viton material?

The current listing describes the material as fluorocarbon / FKM and Viton-equivalent. If a particular brand, compound certificate or traceability document is mandatory, confirm availability before ordering.

Can the maximum listed temperature be used in every application?

No. Media, pressure, duration, coupling design and the specific compound all affect the safe limit. Confirm the complete assembly rating for the intended duty.

What details are needed for quotation?

Provide camlock size, quantity, media, concentration, pressure, temperature range and any certification or documentation requirement. A photo of the existing gasket and coupler can help confirm the profile.

Need an FKM or Viton Camlock Gasket Malaysia quotation? Contact Advtech Engineering with the service details for an availability and compatibility review.